Call: 888-333-4642  

Wiki source for PrimerPump


Show raw source

=====Diesel Primer Pump Replacement=====
====on the 1985 300SD====
===by pwogaman===
===11/29/04===

----
I've gotten loads of free advice from this and other forums. Now it is my turn to share some guidance.
This past May I replaced my original leaking fuel primer pump. It is a simple painless operation that took about 30 minutes - 15 of which was spent taking the attached pictures.

----
**The location of the existing fuel primer pump (next to the injector pump).**
http://www.peachparts.com/diy/primerpump/photo_a.jpg

http://www.peachparts.com/diy/primerpump/photo_b.jpg

----
**The updated replacement part - I paid about $30.00 from a dealer simply because I was on travel and did not want to wait to find it cheaper.**
http://www.peachparts.com/diy/primerpump/photo_c.jpg

----
**Use a hose clamp (I used vise grips) to close off the fuel line after the first stage filter (the clear one).**
http://www.peachparts.com/diy/primerpump/photo_d.jpg

----
**Using a screwdriver, loosen and remove the fuel hose.**
http://www.peachparts.com/diy/primerpump/photo_e.jpg

----
**Using either a 17mm or 19mm socket with an extension, remove the fuel line fitting.**
http://www.peachparts.com/diy/primerpump/photo_f.jpg

----
**Setting the fuel line fitting aside (on top of air filter)**
http://www.peachparts.com/diy/primerpump/photo_g.jpg

----
**Now you have room to access the old primer pump**
http://www.peachparts.com/diy/primerpump/photo_h.jpg

----
**Remove old fuel primer pump with a 24mm open end wrench (note pinched off fuel line at bottom of photo.**
http://www.peachparts.com/diy/primerpump/photo_i.jpg

----
**The new and the old parts compared. The new part came with an adapter that was not required in my application.**
http://www.peachparts.com/diy/primerpump/photo_j.jpg

----
**Clean up and ensure you have removed the old copper washer.**
http://www.peachparts.com/diy/primerpump/photo_k.jpg

http://www.peachparts.com/diy/primerpump/photo_l.jpg

----
**Install new fuel primer pump with a 17mm or 19mm open end wrench.**
http://www.peachparts.com/diy/primerpump/photo_m.jpg

----
**Replace the fuel line fitting, tighten, and enjoy the completed project!**
http://www.peachparts.com/diy/primerpump/photo_o.jpg

----
Next I'll work on posting my project of adding rear headrests. I did this in under an hour with used brackets and leather headrests I got from mercedesdismantlers.com out in L.A. for under $100 - shipped! If done properly it will be no different than if it was factory installed.

**- pwogaman**
----
CategoryDiy
Valid XHTML :: Valid CSS: :: Powered by WikkaWiki



PeachParts, LLC all rights reserved 1999 -
PeachParts, LLC takes no responsibility whatsoever for any technical assistance offered by anyone. The Risk is 100% yours.