View Single Post
  #4  
Old 07-13-2001, 07:53 PM
engatwork's Avatar
engatwork engatwork is offline
busy
 
Join Date: May 2000
Location: Soperton, Ga. USA
Posts: 11,772
shoulda never tried it on Friday 13th

I used the correct rental "tool" to press the new ball joints in but ran into a hitch. The tool was worn at the ends which, after completing the press, I noticed was not exactly a flush fit on the back of the ball joint where the flat part is. Has it got to be exactly flush?
thanks
__________________
Jim
Reply With Quote