View Single Post
  #8  
Old 01-05-2006, 12:29 PM
Brian Carlton Brian Carlton is offline
Banned
 
Join Date: May 2002
Location: Blue Point, NY
Posts: 25,396
I had a similar situation on the 617. The wires that reach around the engine get old and brittle from the heat and the insulation cracks. In this case, it appears that it was rubbing on the bracket directly below the wire.

Not a big deal but it should be fixed by getting out a roll of electrical tape and carefully wrapping the wire from one end to the other. Stretch the tape as you do this to get a tight seal to the wire. Naturally removing the wire from the switch will make the job much easier.
Reply With Quote