View Single Post
  #1  
Old 07-27-2001, 09:40 PM
engatwork's Avatar
engatwork engatwork is offline
busy
 
Join Date: May 2000
Location: Soperton, Ga. USA
Posts: 11,777
I just completed replacing the tie rods, upper control arms and lower ball joints on my 300D. Prior to installing the new tie rods I got them as close as I could to the length of the old ones. During the test drive it is quite evident it is not aligned but the creaks that I could hear when going over bumps are gone - mission accomplished.
Is there anything I can do at home to bring it into somewhat of an alignment? I will get it to the alignment shop over the next couple of days but I would like to get it as close as possible prior to taking it over there.
thanks
__________________
Jim
Reply With Quote