[QUOTE=angst]Yes correct. The reciever part just butts up against the cross bar. [\Quote]
I was searching for cost of this reciever part to weld on the bar.. What is it called? A reciever adapter? . Also then you need a "ball mount" right?
Quote:
|
Also I have a hitch already made that I built for my old 116. Check if you have the 4 hole pattern or 3 hole pattern to bolt your bumper on and it may fit. The extra one I have is the 4 hole pattern.
|
I have the 3 hole mounting brackets that hold the bumper posts to the chassis. The posts are about 40" on center. Perhaps 2 of the holes would line up?
Or perhaps you would charge more and weld 3 hole mount brackets on it for me
. Tomorrow I can get the pattern.
If not, I found a 2000lb gtw (gross trailer weight) / 200 lb tounge weight fixed tounge for 80.00 . That will do for now as I need to go pick up my new camping trailer.
I have another car I can put this one on I dont use as much when I get a better hitch or i m sure someone here would buy it.
According to thread