View Single Post
Old 09-28-2001, 08:51 PM
engatwork's Avatar
engatwork engatwork is offline
Join Date: May 2000
Location: Soperton, Ga. USA
Posts: 11,877
300D hood hinge replacement question

I am in the process of the replaceing the drivers side front hood hinge. It looks like I can grind off the existing rivit without any problem. I would like to go back with the same type of rivet. Any advice on how to "flatten" it out to duplicate what is currently there. Looks like it should be possible with the right tool. I am thinking about coming up with something using "c" clamps to make it like original. thoughts/opinions are appreciated
Reply With Quote