Quote:
Originally Posted by Shorebilly
I think I got that out with some needle nose pliers, patience, anti-anxiety drugs, and if you screw your mouth up just right....
SB
|
That is very good advice. Last week I was drilling out a broken off bolt from the Tecumseh 6HP engine on my Troy Built Horse roto tiller. I had drilled my pilot hole which is typically the hardest part and was just about done with the next size up and it broke off.
I was able to get it out and then broke another one off
It tool me a while and a pair of Swiss needle nose tweezers and a pin punch and a hammer to get it out. Finally got it all done, but it was a 2 hour job that turned into a 5 hour job.