-Since I may go to biodiesel sometime what o ring material should I buy? -
-How many orings for each nozzle?
-Would this leak be a cause of my low power problem?
-Where can I get the special socket?
-Assume I slightly losen the clamp before taping on it?
-When putting the nozzles back in without the special socket assume I just take up finger tight (is that tight enough or should I use little pressure with lock pliers?) and then tightly fasten the hold down clamps?
-Anybody have a cutway of the IP and IP nozzles?
-If I find the socket anybody know the proper torque setting?

thanks