View Single Post
Old 11-22-2001, 10:40 PM
Steve190E 2.3 Steve190E 2.3 is offline
Registered User
Join Date: May 1999
Location: Calgary, Alberta, Canada
Posts: 190
Is it difficult to replace governor seal on transmission?

I asked this question before, but I did not quite get an answer. I seem to have a leak coming from the governor seal on my 1988 300E. It is near the back on the driver's side of the transmission. It is a round cover with a high poing in the middle that looks like a screwdriver would go in. Is there any springs or anything I should worry about before removing the clip that holds the cover in place? I borrowed a picture from to help explain the part more clearly.

Thanks in advance.
Attached Thumbnails
Is it difficult to replace governor seal on transmission?-12point_nut_remove.jpg  
Reply With Quote