View Single Post
Old 12-04-2001, 08:52 PM
Posts: n/a
Not enough information for solution to your misfire. However I would clean trigger points for fuel injection. They are located in ignition distributer below ignition points. They may be accessed by removing the two slotted head screws on the plate with the wiring harness attached to it that is on the side of the distributer. I think you will find these points, (there are two sets) saturated with oil, this is from blow by gasses that come up the distributer shaft, and condense on contact point surfaces of trigger points. This is a very common problem with EFI fuel injected Mercedes, especially the earlier models. New distributer shaft seal in 1974 if I remember correctly.

Reply With Quote