Originally Posted by dpetryk

Thanks John.

I have access to the connection. It looks like its going to be a challenge to get to it with double wrenches.

I have checked the 3 vacuum pods that I can see at this point and it looks like the one for the center vents needs to be replaced. It is riveted in place. I can get the 3 speed nuts off to replace the pod but it looks like the rivet holding the rod needs to be removed since the new pod does not have the rod attached. That one is going to be tuff while it is in place both to remove and to replace.

Have you done a replacement on this pod? If so how did you go about doing it?

Thanks again.