View Single Post
  #2  
Old 12-01-2007, 10:59 PM
dmorrison's Avatar
dmorrison dmorrison is offline
Registered User
 
Join Date: Dec 2002
Location: Colleyville, Texas
Posts: 2,695
Picture #1
Tools and parts needed for the job on a 1985 300D
½ inch drive ratchet.
Special socket. MB tool 115 589 02 07 00
Brass drift.
Hammer
Dead blow hammer
3 jaw puller
Large flat washer or plate ( used with the 3 jaw puller over the hub opening)
Dial gauge, Metric preferred, SAE OK ( it's what I have)
Large flat screwdriver
Flat chisels, 2 small, 2 large
Dial gauge base holder
Wheel bearing kit MB part number 123 350 00 68 ( 1985 300D)
MB wheel grease MB part number 002 989 51 10

Picture #2
Remove the center bolt holding the axle to the hub. You may have to use the brass drift to remove the axle.
Unbolt the caliper.

Picture #3
Hang the axle and caliper with wire , out of the way. Do not
Allow the caliper to hang on its rubber hose. Do not allow the axle to drop.

Picture #4
Remove the rotor. Parking brake must be released to remove the rotor.

Picture #5
The slotted nut and inner bearings.

Dave
Attached Thumbnails
Replacing the rear wheel bearings on a W123, W126-picture-1.jpg   Replacing the rear wheel bearings on a W123, W126-picture-2.jpg   Replacing the rear wheel bearings on a W123, W126-picture-3.jpg   Replacing the rear wheel bearings on a W123, W126-picture-4.jpg   Replacing the rear wheel bearings on a W123, W126-picture-5.jpg  

__________________
1970 220D, owned 1980-1990
1980 240D, owned 1990-1992
1982 300TD, owned 1992-1993
1986 300SDL, owned 1993-2004
1999 E300, owned 1999-2003
1982 300TD, 213,880mi, owned since Nov 18, 1991- Aug 4, 2010 SOLD
1988 560SL, 100,000mi, owned since 1995
1965 Mustang Fastback Mileage Unknown(My sons)
1983 240D, 176,000mi (My daughers) owned since 2004
2007 Honda Accord EX-L I4 auto, the new daily driver
1985 300D 264,000mi Son's new daily driver.(sold)
2008 Hyundai Tiberon. Daughters new car

Last edited by dmorrison; 12-01-2007 at 11:20 PM.
Reply With Quote