View Single Post
Old 03-18-2002, 01:06 PM
Zeus's Avatar
Zeus Zeus is offline
Moderating, Eh?
Join Date: Feb 2000
Location: Canada
Posts: 1,774
I did this job on my old '71 250. I didn't have to remove the whole drive shaft. I simply disconnected it at the tranny end, undid the bearing carrier from the chassis - and here's the iffy part - I used a Dremel to cut through the old bearing carrier and bearing. Since I was going to replace these anyway, I saw no reason to keep them. I actually stopped a few mm short of the actual shaft and used a hammer to snap the bearing off so I wouldn't damage the driveshaft. Once these had been cut through, it was easy to slip on the new carrier and bearing. I'm not sure how different your driveshaft and components are but they should be similar. It might be worth looking into - much easier than dropping the whole driveshaft.
2007 E550 4Matic - 61,000 Km - Iridium Silver, black leather, Sport package, Premium 2 package
2007 GL450 4Matic - 62,000 Km - Obsidian Black Metallic, black leather, all options
1998 E430 - sold
1989 300E - 333,000 Km - sold
1977 280E - sold
1971 250 - retired

"And a frign hat. They gave me a hat at the annual benefits meeting. I said. how does this benefit me. I dont have anything from the company.. So they gave me a hat." - TheDon
Reply With Quote