Quote:
Originally Posted by Cr from Texas
I got a defective mono valve repair kit about 6 months ago.
Check the connections and be sure you are getting 12V.
Open the valve and apply 12V to the terminals. Does the valve advance about 1/2 inch (closed) and hold that position? The defective one (actually two) I bought cheap would just stutter and not stay closed.
|
Once again, you guys are on point. Thank you so much.
I have 12v going to the connection there. I pulled the valve out to inspect the travel distance and you're right; it only travels about 1-2 mm when current is applied. I suppose the problem part more likely the valve itself than the inductive housing, right?