>

That is the problem..

The neg of the coil should have ONLY the blk wire from the Pert Module...
And the Pos of the coil wants the Red from Pert and 12v from the Ign sw.
When you use the Flame Coil, you do not use the ballast ..
If you had a neg wire from the coil to bat, you may have burnt up the new coil..
Do the test again w/o that ground wire... it is not needed, as the Pert does the grounding.....thereby triggering the coil..

Wire it as the instuction tell you....they do not tell you to ground the coil neg....

__________________
A Dalton