View Single Post
Old 05-16-2002, 05:50 AM
engatwork's Avatar
engatwork engatwork is offline
Join Date: May 2000
Location: Soperton, Ga. USA
Posts: 11,232
Can't someone please explain what I need to do to separate this slide rail from the block/cylinder head to allow removal of the head. I sure would like to be able to get the head off over the next day or so.
Surely someone on here has pulled a cylinder head on an E320, 104 engine with this type of slide rail arrangement.
Based on everything I have been able to read/study so far it looks like this pin should pull out and that it is just a press fit into the block. I just need confirmation that it does pull out.
Also, is this the type of slide rail where the plastic piece on the slide rail can be replaced without replacing the rail?

Reply With Quote