|
Since I didn`t have a 27mm, I used a 1 1/16in. Cut out the width on the pipe.
One side has to be ground down to clear the injection Pump. wrench is
8 inches long.
Use a 7/8 open end on the cooler as a back up to take the stress off the cooler incase the nut is corroded on.
cooler is aluminium with steel oil cooler line nut.
Use Anti-seiz on the threads when replacing the lines.
There is a fix from MB called "Screwed Nipples" (for real) if the oil cooler threads get stripped.
Charlie
__________________
there were three HP ratings on the OM616...
1) Not much power
2) Even less power
3) Not nearly enough power!! 240D w/auto
Anyone that thinks a 240D is slow drives too fast.
80 240D Naturally Exasperated, 4-Spd 388k DD 150mph spedo 3:58 Diff
We are advised to NOT judge ALL Muslims by the actions of a few lunatics, but we are encouraged to judge ALL gun owners by the actions of a few lunatics. Funny how that works
|