View Single Post
  #5  
Old 08-29-2009, 02:37 AM
charmalu charmalu is offline
Registered User
 
Join Date: May 2007
Location: Out in the Boonies of Hot, Dry, Dusty, Windy Nevada
Posts: 9,585
OM617 Engine Oil Cooler Line WRENCH

Since I didn`t have a 27mm, I used a 1 1/16in. Cut out the width on the pipe.

One side has to be ground down to clear the injection Pump. wrench is
8 inches long.

Use a 7/8 open end on the cooler as a back up to take the stress off the cooler incase the nut is corroded on.

cooler is aluminium with steel oil cooler line nut.

Use Anti-seiz on the threads when replacing the lines.

There is a fix from MB called "Screwed Nipples" (for real) if the oil cooler threads get stripped.

Charlie
Attached Thumbnails
Home Made Special Tools, This is where members can share how they made special tools-oil-cooler-line-wrench-007-medium-.jpg   Home Made Special Tools, This is where members can share how they made special tools-oil-cooler-line-wrench-2-009-medium-.jpg   Home Made Special Tools, This is where members can share how they made special tools-oil-cooler-line-wrench-013-medium-small-.jpg   Home Made Special Tools, This is where members can share how they made special tools-oil-cooler-line-wrench-016-medium-.jpg  
__________________
there were three HP ratings on the OM616...

1) Not much power
2) Even less power
3) Not nearly enough power!! 240D w/auto

Anyone that thinks a 240D is slow drives too fast.

80 240D Naturally Exasperated, 4-Spd 388k DD 150mph spedo 3:58 Diff

We are advised to NOT judge ALL Muslims by the actions of a few lunatics, but we are encouraged to judge ALL gun owners by the actions of a few lunatics. Funny how that works

Last edited by whunter; 09-01-2009 at 10:52 AM. Reason: copied to this thread
Reply With Quote