Quote:
Originally Posted by badgator
Drove about 3500 miles a month before, no problem, other than filter.
I replaced support + bearing - as I could feel a bad vibe when starting out.
I used a automatic center punch to mark - front ds to rear ds, front flange
to fr ds, rear ds to rr flange.
Flex discs no cracks, and bolt surfaces cleaned, did not line up marked ds
ends to flanges.
Lined up marks only on both ds's, had ds vibe about 50mph.
Maybe ds marks were off, moved one spline, as marks were close.
Vibe at 45mph.
Any ideas?
|
Dang it, this is exactly the situation I have right down to punch marking the ds halves. I have done both the bounce and lthe loosen and roll scenario to no avail.
I have not pulled the shaft out yet and likely will not till the car is parked for winter.
I will be interested in your progress