View Single Post
Old 06-24-2002, 12:47 PM
Stevo's Avatar
Stevo Stevo is offline
Registered User
Join Date: Apr 2002
Location: NW WA
Posts: 6,285
thanks for the reply. #1 was found needing to be bored out 0.30 which should be more than the .6mm needed for the over sized pistons. I was told that cylinder had the most wear. So you are saying to just sleeve the holes that need it and use the oversized pistons. no I have not got the pistons yet. Do you think this job has a good chance of being done right by a shop that has not done MBs but has done other brand diesel sleeves and has a good general reputation?

1985 Euro 300TD 5 spd 220K
1985 Euro 240D 5 spd 130K
1979 240D 5 spd, 40K on engine rebuild
1994 Dodge/Cummins, 5 spd, 121K
1964 Allice Chalmers D15 tractor
2014 Kubota L3800 tractor
1964 VW bug

"Lifes too short to drive a boring car"
Reply With Quote