View Single Post
Old 07-25-2002, 01:59 PM
joe p joe p is offline
it leaks, its german
Join Date: Mar 2002
Location: raleigh nc
Posts: 1,111
remove the t-stat housing, get a light under the intake pointing to the rear of the pump. the bolts are about 3/8" above the cast block and about 3/8" towards the front from the rear lip of the housing. they can be seen, barely.

I cant really describe the angle other than it's hard on the neck. I normally have the car raised, stand in front,lean over the intake and kinda aim my eyes between the pump body and the the intake. bad spot, if you can get 3 out, take a mallet and knock the pump clockwise, you'll see it then.

the 6mm flex is 1/4 drive, I use a adaptor to get to 3/8's drive.

Project Smoker, '87 603 powered wagon
Hauler, 96 CTD can you say torque?
Toy 73 Cougar xr7 convertible
Acme Automotive Inc.
Raleigh NC
Reply With Quote