Thread: ABS brakes
View Single Post
Old 01-23-2000, 10:04 PM
Nick Taflan
Posts: n/a
<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by metricman:
I would rebleed the brakes, make sure that all of the bleeders screws were tightened...always check the basics first. I assume that none of the pads and discs are worn out.

It is always possible that the new master cylinder is bad, but I do not see the ABS hydraulic unit causing this problem, they have been real reliable other than an occaisional relay or something.

Nick here again-thanks for the rapid reply-most appreciated! Perhaps my bleeding technique is in error.Could you advise?
Reply With Quote