View Single Post
  #17  
Old 08-27-2010, 05:37 PM
mercmad6.3 mercmad6.3 is offline
Registered User
 
Join Date: Jun 2004
Location: brisbane,Qld.Australia
Posts: 2,066
At the most there will only be the wires and the vacuum line. remove the inner lining from the kick panel ,undo the door ling and simply disconnect the wires and pull them back from the door into the footwell. Buy a new tube from the classic center . tie a piece of cord to each wire and fit the tube to the cowl while pulling the wires etc into the tube. Do the same on the door and reconnect the wires. Think of it this way...if the car was built,you can rebuild it.
Reply With Quote