View Single Post
Old 09-03-2002, 09:41 PM
Gilly's Avatar
Gilly Gilly is offline
Registered User
Join Date: Mar 2001
Location: Evansville WI
Posts: 9,616
On the connector from the multifunction switch, check continuity between pin 2 (white wire) and pin 11 (black with yellow and green). The power supply to pin 11 is fuse 32, so check that if there is no power on the body side of that connector, but an ohmmeter in the socket (switch) side of 2 and 11 will tell you if the switch is OK, it uses these 2 wires for both constant highbeam and flash mode. You can also check the fuses under the left panel next to the light switch itself, I can't find a fuse assignment for those fuses. If the switch and fuses chaeck out OK, I would begin to suspect the lamp control module, which is also the headlight switch.

Reply With Quote