View Single Post
Old 09-18-2002, 10:53 PM
william rogers william rogers is offline
Registered User
Join Date: Jan 2001
Location: oregon
Posts: 2,013
when I had the lower pan off my SE I noticed that the inner square nut was held by four small spot welds was tempted to it braze for more shear stregth but didn't.It's not hard at all to take lower pan off at least on the V8's (about 10 minutes) then you could safely heat it to get that devil out .give you a chance to clean pan of thoses nasty looking meatal particles that hide in the bottom of pan and put a fresh gasket on........
William Rogers.....
Reply With Quote