Quote:
Originally Posted by scottmcphee
I think it bears repeating that a BRASS brush is used to clean the nozzle area so as not to scratch the metal.
Clarification required: Jeremy did you remove the nozzle pin from the nozzle, then scrub the end of the nozzle, or did you leave the pin in and scrub the lot? And did you do anything special (brass wire?) about cleaning the nozzle pin hole through the nozzle?
thx
|
I soaked my completely disassembled old injectors in carb cleaner and cleaned them with the brass brush and a little brass pick. Pop testing / balancing before installation.