View Single Post
Old 12-13-2002, 09:30 PM
ejsharp ejsharp is offline
Senior Member
Join Date: Mar 2001
Location: Accokeek, MD
Posts: 683
I am looking behind the pully on the bottom side of where I expect the bearing and seal to be along the shaft housing. Where is the hole located? Is it back toward the rear of the car? Is it centered at the bottom radius of the shaft housing or offset to a side?

Anything you may recall regarding its location would be most helpful.

Again thanks.

PS. Do I have to remove anything like a dip stick housing or the tension adjuster in order to see the hole with the mirror?

1993 190E 2.3
2000 Toyota 4x4 Tundra
Reply With Quote