View Single Post
Old 05-12-2000, 05:58 PM
jeffsr jeffsr is offline
Registered User
Join Date: Jan 2000
Location: New Bedford, MA USA
Posts: 1,583
Francis, be careful, if you have a cast aluminum pan, you should not put too much pressure on it. It could crack, and you would end up with an expensive repair job. Book calls for lifting the engine from above. You may have to remove the tranny corssmember and raise the whole assy from below the bottom of the bell housing and tranny pan.

Jeff L
1987 300e
1989 300e
1987 BMW 325
Reply With Quote