View Single Post
  #14  
Old 07-31-2013, 06:49 PM
panZZer panZZer is offline
Banned
 
Join Date: Aug 2008
Location: Texafornia
Posts: 5,493
Quote:
Originally Posted by firstdiesel View Post
NICE! The stuff (poly) in the container is tinted. How do you replicate that? Or do you use sedona red and then clear?
Nope--not tinted--its factory stain bled off--you end up with a un finished raw part--if any polyester spots stick you can grind with a piece of 120 on a 3" rollock --you must be very careful--take it down CLOSE to almost gone but NOT thru the clear, the zebrano veneer is very thin and you can easily bust thru---- (then its time to get some choclate stain and an artist brush to re stripe ~~ had to do that a little bit myself.)

after grinding down close to gone then another nite in the acetone will work over the thin residual clear.
Reply With Quote