View Single Post
  #51  
Old 10-14-2013, 05:26 PM
junker68 junker68 is offline
Registered User
 
Join Date: Jun 2002
Location: Northeast
Posts: 232
I don't know Kerry, I'm just throwing things out there and letting everyone know what I did and tested.

Cooljay, I did remove the 30mm bolt and removed the spring and replace it.
I replaced the two valves, o-rings and cleaned out all of the gunk.

That cam you speak of, it did roll freely, but it was in a stationary position in relation to "pivoting," so to comment on your comment that it is sticking out. It did not move. When pushing on it, the cam did not push into the lift pump housing. I guess your telling me it should, I did not read the link you posted.

Thanks
Reply With Quote