Thread: door lining
View Single Post
Old 06-11-2000, 07:25 PM
Posts: n/a
I had a problem getting the moisture barrier (plastic sheet) to stick after taking the door appart also. I ended up using pieces of cellophane tape to just hold the moisture barrier on the door frame. The molding itself squeezes against the barrier for good measure. Works so far.

I'm having problems with my right front passenger door molding - it seems to have loosened up over the years and the speaker in the door causes the whole thing to rattle a little bit. I used some silicone sealant in between all the parts that were rattling on the drivers side door - this worked, but is there some better way - short of replacing the entire molding?


1990 300D

Reply With Quote