View Single Post
Old 02-25-2003, 04:02 PM
Joseph_H's Avatar
Joseph_H Joseph_H is offline
Registered User
Join Date: Nov 2002
Location: Texas
Posts: 231
Originally posted by tkamiya
Is the pin and the needle indexed or just press fit? Could you have put it back just few degrees off?
No the needle and pin are not indexed or marked to fit in any special way. Since the needle has female end and the gauge has male end just slip the needle over the pin. There is a stopper pin under the number "0" on this gauge to stop the needle from going down further and actually you can sweep the needle all the way up with your finger and watch it fall all the way down to 0 by itself when the gauge is out and no power applied.
Reply With Quote