View Single Post
Old 07-20-2000, 04:50 PM
Steve190E 2.3 Steve190E 2.3 is offline
Registered User
Join Date: May 1999
Location: Calgary, Alberta, Canada
Posts: 190
How would you know if a rod was bent? I know if it was bent enough it would be contacting something i.e. cylinder wall. But I've been told that even a slight bit can cause stress on rod and eventually will let go causing a disaster. I was working on fuel system and a lot of fuel dumped into one of the cylinders. When I went to turn the motor over the starter seemed like there was some force against it not allowing it to turn over. That is why I am thinking the rod may have bent slighly.
Reply With Quote