W116 300SD Turbo Drain Tube poor fitment
While I had my intake/exhaust/turbo assembly removed from my W116 80 300SD I thought I would replace the gasket, grommet and O-rings on the upper and lower drain tube.
As I put it back together you can see from the picture that I can't seem to get them to fit correctly. The intake/exhaust/turbo assembly is bolted in place as is the upper drain tube. The lower drain tube is as low as I can get it.
At one point I took some parts from a W123 but I assume that they should be the same as my car.
Any thoughts or advice?
Thanks,
Paul
|