Just finished the chain tensioner, rails, ect (everyones advise has been most helpful, thanks again). Now I need to fix a preexisting condition.

Checking the fuel pressure at the cold start line, its o.k.. But nothing is arriving at the plugs. Put in new plugs. Still look brand new and no smell of gas on them. This after cranking for a few minutes. Loosen a line at the fuel distributor...no gas escapes. Prior to this and the above mentioned work, the car would not idle.

I have heard that when the EHA (electro hydraulic actuator) go bad can cause strange symptoms. Does it make seen that I am seeing pressure in the cold start circuit but nothing in the main injectors? Where to look? As always.. Thanks