|
Update:
I was able to find a wiring diagram, and get the starter hooked up.
Coolant hose routing and size (injection pump heater?) -Done
Fuel pump hoses and routing. - Engine bay hoses done, still need fuel pump
Where does the temp gauge Sensor go? -Done
Vacuum hose routing. -Done
PCV hose routing. -Done
How to time the ignition - Still don't know
Where does the remote P S reservoir mount? -Done
Oil filter housing check valves location. -Done
I need to figure out how to hook up the cold start valve, and also the solenoid on the back of the IP (not sure what it is for)
Also, I have two distributors, and they appear to have opposite rotation. Is the carb'd distributor different from the one used on the F.I.?(opposite rotation).
Anyone know what PSI fuel pump is needed for this engine? I am planning on going aftermarket. Would an inline F.I. pump made for your basic common rail injection system be too much pressure?
|