View Single Post
Old 04-16-2003, 07:33 AM
pat201 pat201 is offline
Registered User
Join Date: May 2001
Posts: 169
I did it - it took 3 sledgehummer hits and the rotor was on the floor. On the other side was rusted quite a bit.
I noticed one think - before the rotor came out when I was turning the rotor an uneven noise came from behind it - could it be the wheel bearing going bad? Now that I have the rotor out should I venture and re-pack the bearings as well or do I need a special tool which I probably don't have.
Reply With Quote