Hey all. Rebuilding my generator never done a Bosch, they're built well. Both shaft ends have sleeves/slingers on them and I'm a little concerned about putting the puller on them. Any suggestions?
Would like to see an exploded view of it but haven't found any yet.
Brushes and bearings are available but would like to replace the springs also. Found them over seas but both companies don't ship to the U.S. not the first time dealing with that issue.
Generator # 0 101 302 022
Brush# 1 107 014 146
Spring# 1 109 999 071
Electrically everything ohms out good, just needs cleaning etc.
Thanks for the help

Attached Thumbnails