Quote:
Originally Posted by Frank Reiner
m:
Possible causes:
> OVP relay defect. Is the idle speed too high? Is the ABS light on?
> Mixture very lean (outside the range of compensation).
> O2 sensor shorted to ground.
> No current to EHA, or EHA unplugged.
> Defective CIS controller.
|
Idle speed is normal. No ABS light.
EHA is plugged in. When reading the voltage on the x11 port it does change, and there is a marked difference between when the eha is connected and when it is not.
Like and idiot I was messing around with the mixture without a proper multimeter. I probably leaned it out way too much.