View Single Post
Old 09-12-2000, 02:15 PM
Posts: n/a
I've almost gotten this car running perfect. 26mpg town and 31 hwy. Plugs run white around curve to light tan at the tip. BUT there is a slight hesitation when I'm pulling out and winding it up 2500 - 3500 rpm(not punching it but winding it out, light load) Also it doesn't do it when the engine is cold or until about 75-80C. I've taken a variable resistor and hooked it up AS the temperature sensor for the ignition module. At 750 to 800 ohms the hesitation quits. Both the temperature sensors read 340 ohms at running temperature. What do you think? Do you know what the gray area is between cold and warmed up? I plan to run a tank of gas through to check the mileage...
This car was serviced at the MB place of purchase all the way through 127K miles. I got it at 132K.
New, plugs, wires, distributor cap, rotor, vac line looks good.....
Reply With Quote