View Single Post
Old 06-19-2003, 05:57 PM
yal's Avatar
yal yal is offline
Join Date: Oct 1999
Location: New York, Long Island
Posts: 2,704
Yes stick the shim to the back of the pad. Note the protruding clips on either side of the shim? After you stick the shim on you have to bend those clips down and around the pad edge. You will see grooves on either side of the pad edge to allow for this. They look something like this ] [

Make sure you put the shim on the pad the right way up. The curve at the top has to curve around the pad hole. If you block that hole you will not be able to install your pad sensor. Check out some of the pictures of pads in fastlane for guidance, particularly the Pagids they have their shims already installed.

Last edited by yal; 06-19-2003 at 06:11 PM.
Reply With Quote