View Single Post
Old 11-01-2000, 10:50 AM
stevebfl stevebfl is offline
Join Date: Mar 2000
Location: Gainesville FL
Posts: 6,844
There are covers on the side and bottom of the pump, the feed pump has a gasket and there is a plate in the rear. All these have gaskets or o-rings that can be purchased through MB.

The big o-ring where the pump seals to the motor also leaks oil and is available. It is difficult if not impossible to pinpoint some of these leaks. I might recommend using one of the florescent dye additives to the oil, drive it, then remove the pump and view the area with the black light. If still inconclusive then relace all the seals; the most expensive was $6.75.

Steve Brotherton
Owner 24 bay BSC
Bosch Master, ASE master L1
26 years MB technician

[This message has been edited by stevebfl (edited 11-01-2000).]
Reply With Quote