View Single Post
  #3  
Old 07-18-2003, 08:21 PM
engatwork's Avatar
engatwork engatwork is offline
busy
 
Join Date: May 2000
Location: Soperton, Ga. USA
Posts: 11,777
Should not be an alignment required with lower ball joints unless you remove the tie rod end. I recently did a couple 300SD's and just unbolted the tie rod from the spindle so the tie rod adjustment was not disrupted. On one of them I did the drivers side ball joint boot was intact so I just left it alone. Took about 3 hours including the time to go to my friends house to use his vise.
__________________
Jim
Reply With Quote