View Single Post
  #7  
Old 12-09-1999, 08:55 PM
Tobias MB Tobias MB is offline
Registered User
 
Join Date: May 1999
Location: Charlotte, NC, USA
Posts: 688
M.B.Doc
I'm now working on lower bushings with the degree built in. If you shorten the arm by .148353" it will take out one full degree, so you can see it doesn't take much. One could even use a urethane bushing with offset drilled holes by the amount calculated and staked with a setscrew to keep it from rotating in the arm. Thinking possibly of making arms available on an exchange basis if enough demand is there.

TobiasMB
300SE, 300CE, 190/5.0

[This message has been edited by Tobias MB (edited 12-09-1999).]

[This message has been edited by Tobias MB (edited 12-09-1999).]
Reply With Quote