View Single Post
  #3  
Old 07-30-2003, 12:50 PM
Arthur Dalton Arthur Dalton is offline
Registered User
 
Join Date: Aug 1999
Location: Florida / N.H.
Posts: 8,777
Greg is correct. An open sensor will hold the relay in on default.
However , before changing this sensor , it is also possible that the connector is just giving a poor/bad connection. This shows as open to the control unit and it defaults...so....
Simply unplug it . clean the connections, and try again.
You may also , at the same time, check the sensor in-car with an ohm meter for open. If that is the case , the change is in order....
Reply With Quote