View Single Post
Old 10-13-2003, 09:13 AM
Posts: n/a
ok Evan, your code reader is built correctly by not using a 1k ohm resistor, it's usually built into the LEDS.

Now for some discouraging news, I would clear the codes and hold your breath for a while to see if your ASR light goes out and those codes return. Reason is they are the same codes I had when I discovered the wiring harness was shot on my throttle actuator. There seems to be a few people besides myself lately that have had to replace them and they're not cheap.

Socket 14 codes: EA/CC/ISC

Code 6 - Starter lock-out/back-up lamp switch
Code 11 - Fuel Safety Shut-off Signal
Code 14 - CTP switch
Reply With Quote