View Single Post
Old 12-11-2000, 04:29 PM
Posts: n/a
$110 is a good price.

Use the first oversize and bore the block. Make sure you take the pistons to the machine shop, so they can fit them to the bores when they bore the block.

Better yet, take the block to the machine shop for micing prior to buying the pistons. That way you know that it will clean up at the first oversize before buying the pistons.

The alternative is not cheaper. You would put in the sleeves, then bore to standard and top off the sleeve. More machine work, plus the cost of the sleeve.

Good luck,
Reply With Quote