View Single Post
Old 11-19-2003, 08:34 PM
engatwork's Avatar
engatwork engatwork is offline
Join Date: May 2000
Location: Soperton, Ga. USA
Posts: 11,235
103 engine, belt tensioner question

Any suggestions on how to keep the tensioner adjustment mechanism (as shown on the attached drawing) from going down into the hole in the bracket when trying to put the tensioner into the belt slack position? I have about come to the conclusion that probably the best way to slip the belt on is to use a pry bar to pry the pulley back when I install it instead of messing with this.
Reply With Quote