View Single Post
  #2  
Old 12-04-2003, 05:11 PM
rsmcmahon rsmcmahon is offline
Registered User
 
Join Date: Jul 2003
Location: Tulsa
Posts: 304
Below you will find information on removal and replacement of the starter on W140.........................

Ground cable at battery
disconnect, connect.

Bolts (1)
unscrew, screw in.

Nut (2)
unscrew, screw on.

Shield (3), if present
remove, install.

Electric wiring (4 and 5) at starter (M1)
disconnect, connect.

Screws (6)
unscrew

Starter (M1)
take out from below, insert from below; when doing this, take off existing spacer disc(s) (8) and splash guard (7), if necessary, and fit on.
Attached Thumbnails
Where is the starter & ignition switch located on W140-starter.gif  
Reply With Quote