View Single Post
  #12  
Old 12-22-2000, 12:26 PM
Bamboo77
Guest
 
Posts: n/a
we've got block problems fellas. i just got the call from the machine shop who had just miced my cylinders. the ammount of taper is (drum roll please): .02in i'm not sure what that translates to, but i was informed that the cylinders would have to be bored at least a whole mm; which is too much for o/s pistons of any kind, and would probably make the liners too thin anyway. any advice in this situation would definatly help. the shop isnt open again till tuesday. thanks guys, and merry christmas...
WG
Reply With Quote